LG WT5001CW Service Manual
LG WT5001CW Service Manual |
Area of installation; Install the washer on a firm, flat surface. If the washer is installed on a floor that is inappropriate, you could make considerable noise and vibrate. Set foot levelers; Loosen the 2 front leveling feet locknuts until you can turn the feet with the wrench provided. Turn clockwise to raise the washer or counterclockwise to lower it. Check level; Open the cover, check if the washer is properly leveled, looking down from the top. If you see a gap between the tub and the drum, the washer is not level. Checking of the slope; If the mounting surface is tilted, the washer will vibrate. Do not install on a sloping floor. Horizontal adjustment; Lift up the front of the washer and adjust the level by turning the adjustable feet in the clockwise direction, or using the adjusting plate. The level of confirmation; Position the washer in the original position, confirming the level. The distance between the drain hose and the wall; The distance between the wall and the drain hose must be more than 4 inches (10 cm), and the distance between the wall and elsewhere should be more than 2.5 cm (1 inch).
Before connecting the water supply hose to the water intake, check the type of hose and then choose the correct statement here below. Connect the water supply hose to the tap. Push the water supply hose so that the rubber hose gasket to adhere completely to the tap. Connect the water supply hose to the tap. Connect the water supply hose to tap and then tighten by screwing it clockwise. Check for water leaks. After connecting the hose, open the tap to check for water leaks. Hose connection of water supply to the machine; Connect the water supply hose to the washer and then lock inlet valve by turning the hose connecting piece. Check if there is a seal of rubber inside the connector. A new washing machine must be equipped with new hoses. Old hoses should not be reused.
The washer never should be installed or stored in a place subject to freezing temperatures. If the washer was exposed to freezing temperatures prior to installation, let it keep at room temperature for several hours before use. It can damage the water lines and the internal mechanisms of the washer. The water supply pressure must be between 14.5 psi and 116 psi (100 ~ 800 kPa). If the water supply pressure is more than 116 psi, you must install a pressure reducing valve. If you have a temperature and pressure water uncontrolled, you must install a temperature and pressure relief valve to ensure that the temperature and pressure of the water remain within safe limits. Consult a plumber or electrician if you cannot adjust the temperature and the pressure of the water. If it does not, you may damage the machine. Connect the washer power cord to a grounded outlet. If it does not, a shock or serious injury may occur.
useless piece of shit manual.
ReplyDeleteTook me twenty minutes just to get more than the first two pages to come up, then page 50 comes up with nothing where the parts list is supposed to be.
ReplyDeleteBig disapointment.
Washing machine service in dubai
ReplyDeletehttps://www.hometech.ae/service/washing-machine-service/
UAEs Authorized Major brand Washing Machine Service in Dubai, On-Demand experienced professionals for washing machine service in Dubai.
1634963462742-8